Attention for how to assembling and disassembling LR016 1. In order not to scratch the surface, please make sure the table-board is clean, fill up a fabric. - презентация

1 Attention for how to assembling and disassembling LR In order not to scratch the surface, please make sure the table-board is clean, fill up a fabric or others; tangle something on the petiole of forceps. 2. If the angel or force is not proper, the rotor will not be smooth after assembling; Then please detach the shells, make sure the angel is 45 between folder and main. 3. Because the surface is slick and easy to be scratched, in order not to damage the surface, please pay attention: (1)When press out rotor, please use the forceps carefully; (2)The force of pulling out rotor is equal.

2 Four screws SPK Picture of bottom shell for main board

3 FPC plug Rotor head

4 RF hole

5 Rotor

6 Four Screws on folder

7 Sub LCD Receiver Vibrator motor Folder picture

8 Main LCD Magnet

9 Main points of take out rotor Detach main board shells, plug out FPC connector. Put folder to left, main board to right; Withstand the brim of main board by thumb of left hand, use other four fingers to fix folder. Use forceps to press the rotor head by right hand.

10 Detach rotor scheme

11 Close the angel to about 30, pull out main board as the direction showed. Then you can detach the folder from main board.

12 How to install folder to main board 1. Put FPC into the slot of top shell of main board; 2. Put one side of folder at the rotor position. 3. Put the folder and main board to 90 angel, showed as following picture, use right hand thumb to press the rotor head.

13

14 Fix the folder and main board by left hand as showed picture, press the rotor head with forceps by right hand. Extend the angel to 150, the rotor will be installed.