Chapter 5: Configuring Devices for Management 5-1 Copyright © 1998, Cisco Systems, Inc.

5-2MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Configure a Catalyst® switch IP and SNMP parameters Configure the ATM Switch Processor Module IP and SNMP parameters Configure the Route Switch Module IP and SNMP parameters Upon completion of this chapter, you will be able to: Objectives

5-3MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Enable VLAN configuration Configure SwitchProbe® IP and SNMP parameters Objectives (cont.)

5-4MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Set the agent interface IP address Set the default router IP address Show interface to verify Configuring Catalyst IP Parameters

5-5MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Set the read, read-write, and read-write-all community strings Set the trap receiver address Enable RMON Enable traps Show SNMP to verify Configuring Catalyst SNMP Parameters

5-6MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Set the VTP domain Enable the trunk protocol Configure trunk duplex Verify CDP is enabled Configuring Catalyst VTP and CDP Parameters

5-7MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Configure the IP address and subnet mask Configure the SNMP community strings and trap receiver Copy the running configuration to the startup configuration Configuring ATM Switch Processors

5-8MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Configure the IP address and subnet mask Configure the SNMP community strings and trap receiver Copy the running configuration to the startup configuration Configuring Route Switch Modules

5-9MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Configuring SwitchProbes

5-10MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Configure a Catalyst® switch IP and SNMP parameters Configure the ATM Switch Processor Module IP and SNMP parameters Configure the Route Switch Module IP and SNMP parameters Summary

5-11MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Summary (cont.) Enable VLAN configuration Configure SwitchProbe® IP and SNMP parameters

5-12MCSIConfiguring Devices for Management Copyright © 1998, Cisco Systems, Inc. Lab Diagram RMON Probe Catalyst Switch ATM Switch NMS EIA/TIA-232