Copyright 2003 CCNA 2 Chapter 15 Routing and Routing Protocols By Your Name
Copyright 2003 Objectives Introduction to static routing Dynamic routing overview Routing protocols overview
Copyright 2003 Static Versus Dynamic Routes
Copyright 2003 Why Use a Static Route?
Copyright 2003 The ip route Command Static Routes
Copyright 2003 The ip default-network Command
Copyright 2003 Verifying a Static Route The command show running-config is used to view the active configuration in NVRAM to verify that the static route was entered correctly.
Copyright 2003 Troubleshooting Static Routes The show interfaces command The ping command The traceroute command
Copyright 2003 Dynamic Routing Overview
Copyright 2003 Routed Protocols Versus Routing Protocol
Copyright 2003 Autonomous System
Copyright 2003 Dynamic Routing Operations
Copyright 2003 Classes of Routing Protocols
Copyright 2003 Distance Vector Routing Basics
Copyright 2003 Distance Vector Discovery
Copyright 2003 Complex Metrics
Copyright 2003 Link-State Routing Basics
Copyright 2003 Link-State Network Discovery
Copyright 2003 Link-State Topology Changes
Copyright 2003 Link-State Concerns
Copyright 2003 Distance Vector Versus Link State
Copyright 2003 Path Determination
Copyright 2003 Path Selection and Packet Switching
Copyright 2003 IP Routing Configuration Tasks
Copyright 2003 The router and network Commands
Copyright 2003 Routing Protocols RIP A distance vector interior routing protocol IGRP The Cisco distance vector interior routing protocol OSPF A link-state interior routing protocol EIGRP The Cisco advanced distance vector interior routing protocol BGP A distance vector exterior routing protocol